Local laser heat treatment of AlSi10Mg as-built parts produced by Laser Powder Bed Fusion

Abstract

Today, complex structural components for lightweight applications are frequently manufactured by laser powder bed fusion (PBF-LB), often using aluminum alloys such as AlSi10Mg. However, the application of cyclic load cases can be challenging as PBF-LB produced AlSi10Mg parts typically have low ductility and corresponding brittle failure behavior in the as-built condition. Therefore, this paper presents investigations on the feasibility of a laser heat treatment of PBF-LB produced AlSi10Mg parts to locally increase the ductility and decrease the hardness in critical areas. Potential heat treatment process parameters were derived theoretically based on the temperature fields in the material calculated assuming three-dimensional heat conduction and a moving heat source. PBF-LB produced specimens were then laser heat treated at varying laser power and scan speed. Hardness measurements on metallographic cross sections showed hardness reductions of over 35 % without inducing hydrogen pore growth.