Bitte benutzen Sie diese Kennung, um auf die Ressource zu verweisen:
http://dx.doi.org/10.18419/opus-7076
Langanzeige der Metadaten
DC Element | Wert | Sprache |
---|---|---|
dc.contributor.author | Mariolani, José Ricardo Lenzi | de |
dc.contributor.author | Heisel, Uwe | de |
dc.contributor.author | Roth, Günther | de |
dc.date.accessioned | 2009-12-09 | de |
dc.date.accessioned | 2016-03-31T11:41:52Z | - |
dc.date.available | 2009-12-09 | de |
dc.date.available | 2016-03-31T11:41:52Z | - |
dc.date.issued | 1992 | de |
dc.identifier.other | 318540371 | de |
dc.identifier.uri | http://nbn-resolving.de/urn:nbn:de:bsz:93-opus-48696 | de |
dc.identifier.uri | http://elib.uni-stuttgart.de/handle/11682/7093 | - |
dc.identifier.uri | http://dx.doi.org/10.18419/opus-7076 | - |
dc.description.abstract | The results of an experimental investigation on the influence of the tool geometry and the cutting parameters on the surface quality of Aluminium faced with single crystal diamond tools are presented. The best surface qualities were obtained with a facetted cutter with cutting edge of 1,5 mm at a tool setting angle of 0,5°. The cutting parameter of most influence was the feed, being the smallest values of roughness obtained for 3,6 and 7,3µm/rev. The depth of cut exhibited few influence (in the tested range of depths) on the surface quality and the cutting speed showed no influence. It was realized that the right cooling of the cutting zone is decisive for a good surface quality. | en |
dc.language.iso | pt | de |
dc.rights | info:eu-repo/semantics/openAccess | de |
dc.subject.classification | Diamantwerkzeug , Schneidengeometrie | de |
dc.subject.ddc | 670 | de |
dc.title | Influência da geometria da ferramenta e das condições de usinagem no torneamento de alumínio com diamante monocristalino | pt |
dc.title.alternative | Influence of the tool geometry and the cutting parameters on turning of aluminium with single crystal diamond tool | en |
dc.type | article | de |
ubs.fakultaet | Fakultätsübergreifend / Sonstige Einrichtung | de |
ubs.fakultaet | Fakultät Konstruktions-, Produktions- und Fahrzeugtechnik | de |
ubs.institut | Sonstige Einrichtung | de |
ubs.institut | Institut für Werkzeugmaschinen | de |
ubs.opusid | 4869 | de |
ubs.publikation.source | Revista brasileira de ciências mecânicas 14 (1992), Nr. 1, S. 57-74 | de |
ubs.publikation.typ | Zeitschriftenartikel | de |
Enthalten in den Sammlungen: | 15 Fakultätsübergreifend / Sonstige Einrichtung |
Dateien zu dieser Ressource:
Datei | Beschreibung | Größe | Format | |
---|---|---|---|---|
hei95.pdf | 3,64 MB | Adobe PDF | Öffnen/Anzeigen |
Alle Ressourcen in diesem Repositorium sind urheberrechtlich geschützt.