06 Fakultät Luft- und Raumfahrttechnik und Geodäsie
Permanent URI for this collectionhttps://elib.uni-stuttgart.de/handle/11682/7
Browse
14 results
Search Results
Item Open Access Reducing the uncertainty of lidar measurements in complex terrain using a linear model approach(2018) Hofsäß, Martin; Clifton, Andrew; Cheng, Po WenIn complex terrain, ground-based lidar wind speed measurements sometimes show noticeable differences compared to measurements made with in-situ sensors mounted on meteorological masts. These differences are mostly caused by the inhomogeneities of the flow field and the applied reconstruction methods. This study investigates three different methods to optimize the reconstruction algorithm in order to improve the agreement between lidar measurements and data from sensors on meteorological masts. The methods include a typical velocity azimuth display (VAD) method, a leave-one-out cross-validation method, and a linear model which takes into account the gradients of the wind velocity components. In addition, further aspects such as the influence of the half opening angle of the scanning cone and the scan duration are considered. The measurements were carried out with two different lidar systems, that measured simultaneously. The reference was a 100 m high meteorological mast. The measurements took place in complex terrain characterized by a 150 m high escarpment. The results from the individual methods are quantitatively compared with the measurements of the cup anemometer mounted on the meteorological mast by means of the three parameters of a linear regression (slope, offset, R2) and the width of the 5th–95th quantile. The results show that expanding the half angle of the scanning cone from 20◦ to 55◦ reduces the offset by a factor of 14.9, but reducing the scan duration does not have an observable benefit. The linear method has the lowest uncertainty and the best agreement with the reference data (i.e., lowest offset and scatter) of all of the methods that were investigated.Item Open Access Application of a Monte Carlo procedure for probabilistic fatigue design of floating offshore wind turbines(2018) Müller, Kolja; Cheng, Po WenFatigue load assessment of floating offshore wind turbines poses new challenges on the feasibility of numerical procedures. Due to the increased sensitivity of the considered system with respect to the environmental conditions from wind and ocean, the application of common procedures used for fixed-bottom structures results in either inaccurate simulation results or hard-to-quantify conservatism in the system design. Monte Carlo-based sampling procedures provide a more realistic approach to deal with the large variation in the environmental conditions, although basic randomization has shown slow convergence. Specialized sampling methods allow efficient coverage of the complete design space, resulting in faster convergence and hence a reduced number of required simulations. In this study, a quasi-random sampling approach based on Sobol sequences is applied to select representative events for the determination of the lifetime damage. This is calculated applying Monte Carlo integration, using subsets of a resulting total of 16 200 coupled time-domain simulations performed with the simulation code FAST. The considered system is the Danmarks Tekniske Universitet (DTU) 10 MW reference turbine installed on the LIFES50+ OO-Star Wind Floater Semi 10 MW floating platform. Statistical properties of the considered environmental parameters (i.e., wind speed, wave height and wave period) are determined based on the measurement data from the Gulf of Maine, USA. Convergence analyses show that it is sufficient to perform around 200 simulations in order to reach less than 10 % uncertainty of lifetime fatigue damage-equivalent loading. Complementary in-depth investigation is performed, focusing on the load sensitivity and the impact of outliers (i.e., values far away from the mean). Recommendations for the implementation of the proposed methodology in the design process are also provided.Item Open Access Comparison of measured and simulated structural loads of an offshore wind turbine at Alpha Ventus(2016) Müller, Kolja; Reiber, Mario; Cheng, Po WenA comparison of fatigue and extreme loads from simulations with full-scale measurements collected over a period of ten months in the offshore test field, Alpha Ventus, is presented in this paper. There are two goals of this study: (1) to check if the measured range of fatigue and extreme loads can be captured correctly by simulations when the variations of relevant environmental parameters are taken into account; and (2) to investigate if measured extreme loads can be reproduced by simulations when ten-minute averages of the environmental parameters are used. The results show a good overall match of loads when the variation of environmental parameters is considered but an insufficient match when the events of maximum load occurrence are compared.Item Open Access Lidar-based wake tracking for closed-loop wind farm control(2017) Raach, Steffen; Schlipf, David; Cheng, Po WenThis work presents two advancements towards closed-loop wake redirection of a wind turbine. First, a model-based wake-tracking approach is presented, which uses a nacelle-based lidar system facing downwind to obtain information about the wake. The method uses a reduced-order wake model to track the wake. The wake tracking is demonstrated with lidar measurement data from an offshore campaign and with simulated lidar data from a simulation with the Simulator fOr Wind Farm Applications (SOWFA). Second, a controller for closed-loop wake steering is presented. It uses the wake-tracking information to set the yaw actuator of the wind turbine to redirect the wake to a desired position. Altogether, the two approaches enable a closed-loop wake redirection.Item Open Access Quantification of amplitude modulation of wind turbine emissions from acoustic and ground motion recordings(2023) Blumendeller, Esther; Gaßner, Laura; Müller, Florian J. Y.; Pohl, Johannes; Hübner, Gundula; Ritter, Joachim; Cheng, Po WenItem Open Access FAST.Farm load validation for single wake situations at alpha ventus(2021) Kretschmer, Matthias; Jonkman, Jason; Pettas, Vasilis; Cheng, Po WenThe main objective of the presented work is the validation of the simulation tool FAST.Farm for the calculation of power and structural loads in single wake situations; the basis for the validation is the measurement database of the operating offshore wind farm alpha ventus. The approach is described in detail and covers the calibration of the aeroelastic turbine model, transfer of environmental conditions to simulations, and comparison between simulations and adequately filtered measurements. It is shown that FAST.Farm accurately predicts power and structural load distributions over wind direction with discrepancies of less than 10 % for most of the cases compared to the measurements. Additionally, the frequency response of the structure is investigated, and it is calculated by FAST.Farm in good agreement with the measurements. In general, the calculation of fatigue loads is improved with a wake-added turbulence model added to FAST.Farm in the course of this study.Item Open Access Surrogate modeling and aeroelastic analysis of a wind turbine with down-regulation, power boosting, and IBC capabilities(2024) Pettas, Vasilis; Cheng, Po WenAs the maturity and complexity of wind energy systems increase, the operation of wind turbines in wind farms needs to be adjustable in order to provide flexibility to the grid operators and optimize operations through wind farm control. An important aspect of this is monitoring and managing the structural reliability of the wind turbines in terms of fatigue loading. Additionally, in order to perform optimization, uncertainty analyses, condition monitoring, and other tasks, fast and accurate models of the turbine response are required. To address these challenges, we present the controller tuning and surrogate modeling for a wind turbine that is able to vary its power level in both down-regulation and power-boosting modes, as well as reducing loads with an individual blade control loop. Two methods to derive the setpoints for down-regulation are discussed and implemented. The response of the turbine, in terms of loads, power, and other metrics, for relevant operating conditions and for all control modes is captured by a data-driven surrogate model based on aeroelastic simulations following two regression approaches: a spline-based interpolation and a Gaussian process regression model. The uncertainty of the surrogate models is quantified, showing a good agreement with the simulation with a mean absolute error lower than 4% for all quantities considered. Based on the surrogate model, the aeroelastic response of the entire wind turbine for the different control modes and their combination is analyzed to shed light on the implications of the control strategies on the fatigue loading of the various components.Item Open Access Numerical aspects of a two-way coupling for electro-mechanical interactions - a wind energy perspective(2022) Lüdecke, Fiona Dominique; Schmid, Martin; Rehe, Eva; Panneer Selvam, Sangamithra; Parspour, Nejila; Cheng, Po WenItem Open Access On the effects of inter-farm interactions at the offshore wind farm Alpha Ventus(2021) Pettas, Vasilis; Kretschmer, Matthias; Clifton, Andrew; Cheng, Po WenItem Open Access Investigations on low frequency noises of on-shore wind turbines(2020) Blumendeller, Esther; Kimmig, Ivo; Huber, Gerhard; Rettler, Philipp; Cheng, Po WenThe expansion of renewable energy usage is one of the major social tasks in Europe and therefore requires acceptance and support from the population. In the case of onshore wind turbines, the complaints of local residents are often interpreted as infrasound disturbances conceivably caused by wind turbine operation. To improve the acceptance for wind energy projects, national standards and regulations need to incorporate such low frequency effects. This contribution presents long-term acoustic measurement data of low frequency noise recorded directly near wind turbines (emission) and inside of residential buildings (immission) with the objectives to identify the signal characteristics and main influential parameters. Different locations (wind farm and individual turbine), wind conditions, and time ranges are evaluated. It is shown that various frequency content below 150 Hz (harmonics of blade passing frequency, etc.) is connected to the rotation of the rotor blade and the operation of the generator. Furthermore, stable atmospheric conditions are determined to be of high importance for the transmission of the characteristic signals. For future research, this work also serves as an example for low frequency sound pressure data during operation and shutdown of wind turbines.