Please use this identifier to cite or link to this item: http://dx.doi.org/10.18419/opus-11483
Authors: Fandino, Daniel
Guski, Vinzenz
Wegert, Robert
Möhring, Hans-Christian
Schmauder, Siegfried
Title: Simulation study on single-lip deep hole drilling using design of experiments
Issue Date: 2021
metadata.ubs.publikation.typ: Zeitschriftenartikel
metadata.ubs.publikation.seiten: 21
metadata.ubs.publikation.source: Journal of manufacturing and materials processing 5 (2021), No. 44
URI: http://nbn-resolving.de/urn:nbn:de:bsz:93-opus-ds-115008
http://elib.uni-stuttgart.de/handle/11682/11500
http://dx.doi.org/10.18419/opus-11483
ISSN: 2504-4494
Abstract: Single-lip deep hole drilling (SLD) is characterized by a high surface quality and compressive residual stress in the subsurface of the drill hole. These properties are strongly dependent on the cutting parameters of the SLD process and the actual geometry of the insert and the guide pads. In the present work, full 3D FE simulations of the SLD process were carried out to analyze the thermo-mechanical as-is state in the drilling contact zone by evaluating the feed force, the temperature, as well as the residual stress in the drill hole subsurface. An extensive simulation study was conducted on the effect of the process parameters on the properties using design of experiments (DoE). For the simulations, the Johnson-Cook (JC) constitutive law and the element elimination technique (EET) were applied to represent the material behavior of the workpiece, including chip formation. In-process measurements as well as results from the hole-drilling method to determine residual stresses were conducted to verify the numerical results. By means of DoE and analysis of variance (ANOVA), regression models were developed to describe the effect of the feed rate, cutting speed, and guide pad height on the temperature, feed force, and residual stress in the subsurface.
Appears in Collections:07 Fakultät Konstruktions-, Produktions- und Fahrzeugtechnik

Files in This Item:
File Description SizeFormat 
jmmp-05-00044-v2.pdf5,53 MBAdobe PDFView/Open


Items in OPUS are protected by copyright, with all rights reserved, unless otherwise indicated.