03 Fakultät Chemie
Permanent URI for this collectionhttps://elib.uni-stuttgart.de/handle/11682/4
Browse
7 results
Search Results
Item Open Access Rapid aging as a key to understand deactivation of Ni/Al2O3 catalysts applied for the CO2 methanation(2021) Beierlein, Dennis; Häussermann, Dorothea; Traa, Yvonne; Klemm, EliasWe developed a rapid aging method for Ni/Al2O3 methanation catalysts mimicking the real aging in the actual application. The method is based on hydrothermal deactivation of the catalyst at 600 or 700 °C, which leads to a catalyst with nearly constant conversion after a much shorter time period compared to normal aging. The hydrothermally aged catalysts are characterized by N2 adsorption, X-ray powder diffraction, temperature-programmed reduction and H2 chemisorption. The catalytic performance of the aged catalysts is comparable to the one of a catalyst deactivated in a long-term measurement with up to 720 h on stream. The time needed for reaching a stable conversion can be diminished by rapid aging by a factor of 10. The investigations also showed that the long-term deactivation is caused by Ni particle sintering and that the support pores limit the Ni particle size.Item Open Access Asymmetric Rh diene catalysis under confinement : isoxazole ring‐contraction in mesoporous solids(2024) Marshall, Max; Dilruba, Zarfishan; Beurer, Ann‐Katrin; Bieck, Kira; Emmerling, Sebastian; Markus, Felix; Vogler, Charlotte; Ziegler, Felix; Fuhrer, Marina; Liu, Sherri S. Y.; Kousik, Shravan R.; Frey, Wolfgang; Traa, Yvonne; Bruckner, Johanna R.; Plietker, Bernd; Buchmeiser, Michael R.; Ludwigs, Sabine; Naumann, Stefan; Atanasova, Petia; Lotsch, Bettina V.; Zens, Anna; Laschat, SabineCovalent immobilization of chiral dienes in mesoporous solids for asymmetric heterogeneous catalysis is highly attractive. In order to study confinement effects in bimolecular vs monomolecular reactions, a series of pseudo‐C2‐symmetrical tetrahydropentalenes was synthesized and immobilized via click reaction on different mesoporous solids (silica, carbon, covalent organic frameworks) and compared with homogeneous conditions. Two types of Rh‐catalyzed reactions were studied: (a) bimolecular nucleophilic 1,2‐additions of phenylboroxine to N‐tosylimine and (b) monomolecular isomerization of isoxazole to 2H‐azirne. Polar support materials performed better than non‐polar ones. Under confinement, bimolecular reactions showed decreased yields, whereas yields in monomolecular reactions were only little affected. Regarding enantioselectivity the opposite trend was observed, i. e. effective enantiocontrol for bimolecular reactions but only little control for monomolecular reactions was found.Item Open Access Efficient and spatially controlled functionalization of SBA‐15 and initial results in asymmetric Rh‐catalyzed 1,2‐additions under confinement(2021) Beurer, Ann‐Katrin; Kirchhof, Manuel; Bruckner, Johanna R.; Frey, Wolfgang; Baro, Angelika; Dyballa, Michael; Giesselmann, Frank; Laschat, Sabine; Traa, YvonneSelectively functionalized mesoporous silica may considerably advance heterogeneous catalysis through the controlled immobilization of highly selective complex catalysts inside the mesopores. However, spatially controlled functionalization and the precise analytical verification are still a challenge. In this publication, we report a method, which ensures a selective functionalization of the mesopore surface with a clickable linker and thus makes it possible to study confinement effects during catalyzed reactions. First, we passivate the silanol groups on the particle surface and in the pore entrances of the mesoporous silica material SBA‐15 with 1,1,1‐trimethyl‐N‐(trimethylsilyl)silanamine. Then we remove the template by solvent extraction and functionalize the pore walls with 3‐azidopropyltriethoxysilane before we click the catalyst. In initial experiments of asymmetric Rh‐catalyzed 1,2‐addition, we investigate the performance of a catalyst clicked selectively in the mesopores and compare it to the dissolved catalyst as well as to the catalyst immobilized exclusively on the external surface of SBA‐15.Item Open Access Effect of aluminum and sodium on the sorption of water and methanol in microporous MFI-type zeolites and mesoporous SBA-15 materials(2020) Li, Zheng; Rieg, Carolin; Beurer, Ann-Katrin; Benz, Michael; Bender, Johannes; Schneck, Christof; Traa, Yvonne; Dyballa, Michael; Hunger, MichaelThe interaction and nature of surface sites for water and methanol sorption on MFI-type zeolites and mesoporous SBA-15 were investigated by solid-state NMR spectroscopy and correlated with the desorption enthalpies determined via TGA/DSC. For siliceous Silicalite-1, 29Si CPMAS NMR studies support stronger methanol than water interactions with SiOH groups of Q3-type. On siliceous SBA-15, SiOH groups of Q2-type are accompanied by an enhanced hydrophilicity. In aluminum-containing Na-ZSM-5, Na+ cations are strong adsorption sites for water and methanol as evidenced by 23Na MAS NMR in agreement with high desorption enthalpies of ΔH = 66-74 kJ/mol. Solid-state NMR of aluminum-containing Na-[Al]SBA-15, in contrast, has shown negligible water and methanol interactions with sodium and aluminum. Desorption enthalpies of ΔH = 44-60 kJ/mol hint at adsorption sites consisting of SiOH groups influenced by distant framework aluminum. On H-ZSM-5, Brønsted acidic OH groups are strong adsorption sites as indicated by partial protonation of water and methanol causing low-field shifts of their 1H MAS NMR signals and enhanced desorption enthalpies. Due to the small number of Brønsted acid sites in aluminum-containing H-[Al]SBA-15, water and methanol adsorption on this material is suggested to mainly occur at SiOH groups with distant framework aluminum species, as in the case of Na-[Al]SBA-15.Item Open Access Influence of the synthesis protocol on the catalytic performance of PHI-type zeolites for the dehydration of lactic acid(2023) Häussermann, Dorothea; Schömig, Richard; Gehring, Barbara; Traa, YvonneAcrylic acid is an important basic chemical and a key starting compound for a variety of consumer products. Today, acrylic acid is still produced from fossil-based propene. If acrylic acid were produced from bio-based lactic acid, this would be an important step towards sustainability. The gas-phase dehydration reaction of lactic acid to acrylic acid was performed over eight-membered ring PHI-type zeolites in the Na+ and K+-form. A few variations in the synthesis procedure of PHI-type zeolite made a big difference in the performance during the catalytic reaction due to differences in the physical and chemical properties, especially the accessibility of the pores. The catalysts were characterized with ICP-OES, XRD, CO2 physisorption, SEM and 27Al MAS NMR. The calcination resulted in a partial collapse of the PHI structure. In the case of Na,K-PHI with a low surface area, the catalysis tends to take place on the outer surface, while in the case of Na,K-PHI with a high surface area the catalysis can also take place within the pore system. This has a considerable influence on the selectivity of the catalysts.Item Open Access Cationic molybdenum imido alkylidene N‐heterocyclic carbene complexes confined in mesoporous silica : tuning transition states towards Z‐selective ring‐opening cross‐metathesis(2022) Goldstein, Elizabeth L.; Ziegler, Felix; Beurer, Ann‐Katrin; Traa, Yvonne; Bruckner, Johanna R.; Buchmeiser, Michael R.We recently reported a method for selective macro(mono)cyclization of dienes utilizing catalysts confined inside the pores of mesoporous silica, which we believe occurs due to suppression of oligomerization due to pore size. We hypothesized, however, that the system of cationic molybdenum imido alkylidene N‐heterocyclic carbene (NHC) catalysts immobilized selectively inside the mesopores of silica materials could address much more subtle selectivity differences, such as E/Z selectivity in ring‐opening/cross‐metathesis (ROCM). Upon investigation, we observed that surface‐bound cationic molybdenum imido alkylidene NHC catalysts indeed display an increased Z‐selectivity, especially during the early stages of the reaction. This effect was present when the catalyst was confined inside a pore, as well as when the catalyst was bound to non‐porous silica, which led us to conclude it is an effect caused by the catalyst being bound directly to the surface of a silica material where the proximity of the catalyst to the surface governs the transition state. Kinetic investigations revealed that significant post‐metathesis olefin isomerization occurs, the amount of which seems to be governed by the rate of diffusion of the product away from the active catalyst, with smaller pore sizes resulting in higher Z‐selectivity at higher conversion, attributable to faster diffusion of the product out of the pore than diffusion back into the pore.Item Open Access Investigating the long-term kinetics of Pd nanoparticles prepared from microemulsions and the Lindlar catalyst for selective hydrogenation of 3-hexyn-1-ol(2024) Tari, Faeze; Hertle, Sebastian; Wang, Hongguang; Fischer, Julian; Aken, Peter A. van; Sottmann, Thomas; Klemm, Elias; Traa, YvonneThe effect of non-saturated corner and edge sites of Pd particles on the long-term selectivity of cis-3-hexen-1-ol in the hydrogenation of 3-hexyn-1-ol was studied in this work. Non-supported Pd agglomerates were synthesized through the microemulsion synthesis route and used at nalkynol/APdratios between 0.08 and 21 mol/m2for the catalytic conversion of 3-hexyn-1-ol for 20 h. The selectivity of the cis-hexenol product increased by reducing the quantity of Pd catalytic sites (increasing the nalkynol/APdratio) without introducing any modifier or doping agent to poison the nonselective sites. Then, Pd aggregates with fused primary particles and, thus, fewer corner and edge sites were produced through thermal sintering of the agglomerates at 473-723 K. By comparing the catalytic performance of the agglomerates and aggregates, it was observed that at a rather similar kinetic behavior (99.99% conversion and 85-89% selectivity to cis-hexenol), the sintered aggregates could stay selective despite a catalytic surface area about seven times larger. This emphasizes the role of low-coordinated edge and corner sites on the final selectivity of the cis product and demonstrates that thermal sintering allows the number of non-selective sites to be reduced without any need for toxic or organic doping agents or modifiers.